Ignition Cable

Ignition cable replacement is a relatively easy task and can be done with basic tools. Here are the steps to repair the auto ignition cable:

• Open the hood of the car and locate the auto ignition cable. Depending on the make and model, the cable may be attached to the distributor cap or the auto ignition coil.

• Remove the old cable. Squeeze the retaining tab and gently pull the cable off.

• Install the new cable. Push the cable onto the distributor cap or coil until it is secure.

• Secure the cable. Tighten the retaining nut and make sure the cable is secure.

• Reconnect the negative battery cable. This will prevent any electrical shorts.

• Start the engine and check for proper operation. If the engine does not start, recheck the cable for a secure connection.
  

Replacing an car ignition cable is a simple job that can be done in just a few minutes. With the right tools and a little patience, anyone can repair the car ignition cable and get their car back on the road.

Checking the ignition cable is an important part of maintaining a vehicle. It's important to check the cable regularly to ensure it is in good condition.

First, inspect the cable visually. Make sure there are no visible signs of damage, such as fraying or cracking. Any signs of damage should be addressed immediately.

Second, check the cable for resistance. This can be done with a multimeter. Connect the multimeter leads to the cable and set the meter to measure resistance. The resistance should be between 150 and 180 ohms. If the resistance is outside of this range then the cable should be replaced.

Third, check for continuity. This can also be done with a multimeter. Set the meter to measure continuity and connect the leads to the cable. The meter should indicate the presence of a continuous circuit. If there is no continuity, then the cable should be replaced.

Finally, check the cable for any corrosion. Corrosion can be caused by moisture, which can lead to electrical problems. If any corrosion is present, the cable should be replaced.

By following these steps, you can easily check the ignition cable and ensure it is in good working condition.